transient temperature distribution

The transient temperature distribution and thermal distortion of optical coating components under an annular high-power continuous wave laser radiation

环状连续强激光下光学薄膜的瞬温和热畸变

The influence of heat capacity of the electric heater on the transient temperature distribution in the test plate is discussed.

讨论了电加热器热容量对平板试材温度分布的影响。

Based on the three-dimensions transient temperature distribution model, the paper analyzes the effects of different combination of laser power and scanning velocity on the hardened case's uniformity.

以三维瞬态温度场分布模型为基础，对激光相变硬化中不同激光功率和扫描速度组合对硬化层分布均匀性的影响进行了理论研究。

Calculation of Transient Temperature Distribution in a Moist Coal Stockpile

湿煤堆非稳态温度场计算

The transient heating capacity, coefficient of performance ( COP), cycle parameters of the ASHP system and frost accumulation amount on the outdoor heat exchanger surface, wall temperature distribution along the heat exchange tubes are measured under frosting conditions.

测量了该空调器在不同室外温度、湿度条件下制热量、性能系数（COP）、系统循环参数、室外换热器结霜量及壁面温度分布随结霜时间的变化。

The principles of stress distribution on sections are got by solving the temperature stress distribution of the spatial continuous rigid-frame bridge through coupling heat-transient state and heat-structure.

通过热-瞬态和热-结构耦合求解空间实体连续刚构桥的温度应力分布，求得求截面各点应力分布规律，并与本文提出两种温度梯度分布模式进行了对比。

The temperature distribution on an uncooled infrared bolometer detector is computed using the finite element numerical method. The introduced model can simulate both the steady state and the transient temperature field of the top surface of the thermal sensitive layer on a bolometer detector.

本文主要介绍用有限元数值分析的方法对非致冷红外测辐射热计探测器的温度分布进行计算，其有限元模型可以对测辐射热计探测器热敏层表面的稳态和瞬态温度场进行仿真。

A method for calculating the temperature distribution, thermal stress and low-cycle fatigue of drum walls with a two dimensional transient temperature field is presented, together with a computer program for calculating the low-cycle fatigue life of boiler drums.

提出了非稳态二维温度分布下汽包壁温度和应力分析及疲劳寿命计算方法，并编制了相应的计算机程序。

The transient heat transfer process of the submerged nozzle under two different preheating regimes is studied by CFD of ANSYS and thereupon the temperature field distribution of the nozzle after preheating and its temperature rise curve have been obtained.

运用ANSYS的CFD对浸入式水口两种预热烘烤方式下的瞬态传热过程进行了研究，得到了水口烘烤预热后的温度场分布和水口的升温曲线。